BLIND SPOT MONITOR SENSOR REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during blind spot monitor sensor removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Replacement of blind spot monitor sensor Blind spot monitor beam axis inspection DTCs are output

Click here

PROCEDURE


  1. REMOVE REAR BUMPER ASSEMBLY

    Click here

  2. REMOVE BLIND SPOT MONITOR SENSOR LH


    1. B005PVX

      Disconnect the connector.

    2. Remove the 3 nuts and blind spot monitor sensor LH.

      Note

      Replace the blind spot monitor sensor if it has been dropped or subjected to a severe impact.

  3. REMOVE BLIND SPOT MONITOR SENSOR RH


    1. B005OL3

      Disconnect the connector.

    2. Remove the 3 nuts and blind spot monitor sensor RH.

      Note

      Replace the blind spot monitor sensor if it has been dropped or subjected to a severe impact.