PANORAMIC VIEW MONITOR SYSTEM, Diagnostic DTC:C1625

DTC Code DTC Name
C1625 Open or Short in Steering Angle Sensor +B

DESCRIPTION

This DTC is stored if the parking assist ECU receives a signal via CAN communication from the spiral with sensor cable sub-assembly that indicates a power supply system problem.

DTC No. Detection Item DTC Detection Condition Trouble Area
C1625 Open or Short in Steering Angle Sensor +B Open or short in steering angle sensor +B

  • Harness or connector

  • Steering sensor

WIRING DIAGRAM


  1. w/o Stop and Start System

    B005LSQE67

  2. w/ Stop and Start System

    B005QEIE01

CAUTION / NOTICE / HINT

Note


  • Since the panoramic view monitor system has functions that use the CAN communication system, first confirm that there is no malfunction in the communication system by inspecting the CAN communication functions in accordance with the "How to Proceed with Troubleshooting" procedures. Then, conduct the following inspection procedure.

  • When "!" mark is displayed on the multi-display assembly*1 or accessory meter assembly*2 after the cable is disconnected from the negative (-) battery terminal, correct the steering angle neutral point.

    Click here


    • *1: for 8 Inch Display

    • *2: for 12.3 Inch Display

  • Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the panoramic view monitor system may be needed.

    Click here

  • Inspect the fuses for circuits related to this system before performing the following inspection procedure.

  • The vehicle is equipped with a Supplemental Restraint System (SRS) which includes components such as airbags. Before servicing (including removal or installation of parts), be sure to read the precaution for Supplemental Restraint System.

    Click here

PROCEDURE


  1. CHECK HARNESS AND CONNECTOR (STEERING SENSOR POWER SOURCE)


    1. Disconnect the steering sensor connector.

      Click here

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      J32-1 (ESS) - Body ground Always Below 1 Ω

    3. Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Switch Condition Specified Condition
      J32-4 (IG1) - J32-1 (ESS) Engine switch on (IG)

      11 to 14 V*1

      10.5 to 16*2
      J32-5 (BAT) - J32-1 (ESS) Always 11 to 14 V

      • *1: w/o Stop and Start System

      • *2: w/ Stop and Start System

      Result
      Result Proceed to
      OK A
      NG (w/o Stop and Start System) B
      NG (w/ Stop and Start System) C

    A

    REPLACE STEERING SENSOR Click here

    B

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    C

    GO TO STOP AND START SYSTEM Click here