PANORAMIC VIEW MONITOR SYSTEM HOW TO PROCEED WITH TROUBLESHOOTING

DTC Code DTC Name
HOW TO PROCEED WITH TROUBLESHOOTING

CAUTION / NOTICE / HINT

Tech Tips


  • Use the following procedure to troubleshoot the panoramic view monitor system.

  • *: Use the GTS.

PROCEDURE


  1. VEHICLE BROUGHT TO WORKSHOP

    Result
    Proceed to
    NEXT

    NEXT

  2. INSPECT BATTERY VOLTAGE


    1. Measure the battery voltage with the engine switch off.

      Standard Voltage
      11 to 14 V

      If the voltage is below 11 V, replace or recharge the battery before proceeding.

      Result
      Proceed to
      NEXT

    NEXT

  3. SYSTEM CHECK


    1. Check the vehicle specification.

      Result
      Result Proceed to
      w/ Navigation System A
      w/ Audio and Visual System (for 8 Inch Display) B

    B

    CHECK AUDIO AND VISUAL SYSTEM Click here

    A

  4. CHECK NAVIGATION SYSTEM


    1. Refer to Navigation System.

      Click here

      Result
      Result Proceed to
      Navigation system is normal A
      Navigation system is abnormal B

    B

    GO TO NAVIGATION SYSTEM Click here

    A

  5. CHECK COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM*


    1. Use the GTS to check if the CAN communication system is functioning normally.

      Click here

      Result
      Result Proceed to
      CAN DTCs are not output A
      CAN DTCs are output B

    B

    GO TO CAN COMMUNICATION SYSTEM Click here

    A

  6. CHECK FOR DTC*


    1. Check for DTCs and note any codes that are output.

      Click here


      Chassis > Panoramic View Monitor > Trouble Codes

    2. Clear the DTCs.

      Click here


      Chassis > Panoramic View Monitor > Clear DTCs

    3. Recheck for DTCs. Try to reproduce the DTC by simulating the original activity that the DTC suggests.


      Chassis > Panoramic View Monitor > Trouble Codes
      Result
      Result Proceed to
      DTCs are not output A
      DTCs are output B

    B

    GO TO STEP 9 Click here

    A

  7. PROBLEM SYMPTOMS TABLE


    1. Refer to the Problem Symptoms Table.

      Click here

      Result
      Result Proceed to
      Fault is not listed in Problem Symptoms Table A
      Fault is listed in Problem Symptoms Table B

    B

    ADJUST, REPAIR OR REPLACE IN ACCORDANCE WITH PROBLEM SYMPTOMS TABLE

    A

  8. OVERALL ANALYSIS AND TROUBLESHOOTING*


    1. Data List / Active Test

      Click here

    2. Terminals of ECU

      Click here

      Result
      Proceed to
      NEXT

    NEXT

  9. ADJUST, REPAIR OR REPLACE

    Result
    Proceed to
    NEXT

    NEXT

  10. CONFIRMATION TEST

    Result
    Proceed to
    NEXT

    NEXT

    END

  11. CHECK AUDIO AND VISUAL SYSTEM


    1. Refer to Audio and Visual System.

      Click here

      Result
      Result Proceed to
      Audio and visual system is normal A
      Audio and visual system is abnormal B

    A

    GO TO STEP 5 Click here

    B

    GO TO AUDIO AND VISUAL SYSTEM (for 8 Inch Display) Click here