BLIND SPOT MONITOR SYSTEM, Diagnostic DTC:C1ABD, C1ABE

DTC Code DTC Name
C1ABD Short to +B in Buzzer
C1ABE Short to GND or Open in Buzzer

DESCRIPTION


DTC No. Detection Item DTC Detection Condition Trouble Area
C1ABD Short to +B in Buzzer

    Both of the following conditions are met:

  • The blind spot monitor system is on

  • The blind spot monitor sensor is attempting to sound the buzzer but the buzzer receives voltage above a specified level for a specified period of time

  • Blind spot monitor sensor RH

  • RCTA buzzer (blind spot monitor buzzer)

  • Wire harness or connector
C1ABE Short to GND or Open in Buzzer

    Both of the following conditions are met:

  • The blind spot monitor system is on

  • The blind spot monitor sensor is not sounding the buzzer but the buzzer receives voltage below a specified level for a specified period of time.

  • Blind spot monitor sensor RH

  • RCTA buzzer (blind spot monitor buzzer)

  • Wire harness or connector

WIRING DIAGRAM

B005MNBE47

CAUTION / NOTICE / HINT

Note


  • When checking for DTCs, make sure that the blind spot monitor system is turned on.

  • Inspect the fuses for circuits related to this system before performing the following procedure.

PROCEDURE


  1. CHECK DTC


    1. Turn the engine switch off.

    2. Turn the engine switch on (IG).

    3. Recheck for DTCs and check if the same DTC is output again.


      Body Electrical > Blind Spot Monitor Slave > Trouble Codes
      OK
      No DTCs are output.
      Result
      Proceed to
      OK
      NG

    OK

    USE SIMULATION METHOD TO CHECK Click here

    NG

  2. CHECK HARNESS AND CONNECTOR (RCTA BUZZER - BATTERY AND BLIND SPOT MONITOR SENSOR RH)


    1. Disconnect the S52 RCTA buzzer (blind spot monitor buzzer) connector.

    2. Disconnect the W2 blind spot monitor sensor RH connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      S52-2 (BZN) - W2-3 (BUZ) Always Below 1 Ω
      S52-2 (BZN) - Body ground Always 10 kΩ or higher

    4. Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Condition Specified Condition
      S52-1 (BZP) - Body ground Engine switch on (IG) 11 to 14 V
      S52-1 (BZP) - Body ground Engine switch off Below 1 V
      Result
      Proceed to
      OK
      NG

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

  3. REPLACE RCTA BUZZER (BLIND SPOT MONITOR BUZZER)


    1. Replace the RCTA buzzer (blind spot monitor buzzer).

      REAR CROSSING TRAFFIC ALERT BUZZER (w/o Rear No. 2 Seat): Click here

      REAR CROSSING TRAFFIC ALERT BUZZER (w/ Rear No. 2 Seat): Click here

      Result
      Proceed to
      NEXT

    NEXT

  4. CHECK DTC


    1. Clear the DTCs.

      Click here


      Body Electrical > Blind Spot Monitor Slave > Clear DTCs

    2. Recheck for DTCs and check if the same DTC is output again.


      Body Electrical > Blind Spot Monitor Slave > Trouble Codes
      OK
      No DTCs are output.
      Result
      Proceed to
      OK
      NG

    OK

    END

    NG

    REPLACE BLIND SPOT MONITOR SENSOR RH Click here