DATA LIST
Tech Tips
Using the GTS to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.
Note
In the following table, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
Connect the GTS to the DLC3.
Turn the engine switch on (IG).
Turn the GTS on.
Enter the following menus: Body Electrical / Sliding Roof, Sliding Sunshade or Main Body / Data List.
Read the Data List according to the display on the GTS.
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| Front SW Auto Operation | Sliding roof auto operation function | OFF or ON | Customize setting displayed | - |
| Hall IC1 Pulse | Hall IC1 pulse output | Lo or Hi | Lo and Hi repeat during motor operation | Lo: Hall IC1 output is low Hi: Hall IC1 output is high |
| Hall IC1 Status | Status of Hall IC1 | Normal or Error | Normal: Hall IC1 normal Error: Hall IC1 not normal |
- |
| Hall IC2 Pulse | Hall IC2 pulse output | Lo or Hi | Lo and Hi repeat during motor operation | Lo: Hall IC2 output is low Hi: Hall IC2 output is high |
| Hall IC2 Status | Status of Hall IC2 | Normal or Error | Normal: Hall IC2 normal Error: Hall IC2 not normal |
- |
| Ignition (Direct Signal) | Engine switch signal | OFF or ON | OFF: Engine switch off ON: Engine switch on (IG) |
- |
| Ignition (MPX) | Engine switch signal (LIN signal) | OFF or ON | OFF: Engine switch off ON: Engine switch on (IG) |
- |
| Door Courtesy | Driver door courtesy light switch signal | OFF or ON | OFF: Driver door closed ON: Driver door open |
- |
| Door Key Close Operation | Key-linked sliding roof close signal | OFF or ON | OFF: Driver door key cylinder not turned ON: Driver door key cylinder turned and held at the lock position |
- |
| Door Key Open Operation | Key-linked sliding roof open signal | OFF or ON | OFF: Driver door key cylinder not turned ON: Driver door key cylinder turned and held at the unlock position |
- |
| Wireless Close Operation | Wireless transmitter-linked sliding roof close signal* | OFF or ON | OFF: Transmitter LOCK switch not pressed ON: Transmitter LOCK switch pressed and held |
- |
| Wireless Open Operation | Wireless transmitter-linked sliding roof open signal* | OFF or ON | OFF: Transmitter UNLOCK switch not pressed ON: Transmitter UNLOCK switch pressed and held |
- |
| Key Off Permission | Key-off sliding roof operation permit signal | OFF or ON | OFF: Any status except "ON" status ON: Front doors are not opened within 45 seconds after engine switch turned off |
- |
| Vent Switch | Sliding roof tilt switch signal | OFF or ON | OFF: Sliding roof switch not pressed ON: Sliding roof switch pressed |
- |
| Roof Open Switch | Sliding roof open switch signal | OFF or ON | OFF: Sliding roof switch not slid backward ON: Sliding roof switch slid backward |
- |
| Roof Close Switch | Sliding roof close switch signal | OFF or ON | OFF: Sliding roof switch not slid forward ON: Sliding roof switch slid forward |
- |
| Shade Close Switch | Roof sunshade close switch signal | OFF or ON | OFF: Roof sunshade switch not slid forward ON: Roof sunshade switch slid forward |
- |
| Shade Open Switch | Roof sunshade open switch signal | OFF or ON | OFF: Roof sunshade switch not slid backward ON: Roof sunshade switch slid backward |
- |
| Current Roof Open Switch Stuck ON | Sliding roof open switch stuck signal (Current) | OFF or ON | OFF: No sliding roof switch stuck signal (Current) ON: Sliding roof switch stuck signal (Current) |
- |
| Current Roof Close Switch Stuck ON | Sliding roof close switch stuck signal (Current) | OFF or ON | OFF: No sliding roof switch stuck signal (Current) ON: Sliding roof switch stuck signal (Current) |
- |
| Current Shade Close Switch Stuck ON | Roof sunshade close switch stuck signal (Current) | OFF or ON | OFF: No roof sunshade switch stuck signal (Current) ON: Roof sunshade switch stuck signal (Current) |
- |
| Current Shade Open Switch Stuck ON | Roof sunshade open switch stuck signal (Current) | OFF or ON | OFF: No roof sunshade switch stuck signal (Current) ON: Roof sunshade switch stuck signal (Current) |
- |
| Past Roof Open Switch Stuck ON | Sliding roof open switch stuck signal (Past) | OFF or ON | OFF: No sliding roof switch stuck signal (Past) ON: Sliding roof switch stuck signal (Past) |
- |
| Past Roof Close Switch Stuck ON | Sliding roof close switch stuck signal (Past) | OFF or ON | OFF: No sliding roof switch stuck signal (Past) ON: Sliding roof switch stuck signal (Past) |
- |
| Past Shade Close Switch Stuck ON | Roof sunshade close switch stuck signal (Past) | OFF or ON | OFF: No roof sunshade switch stuck signal (Past) ON: Roof sunshade switch stuck signal (Past) |
- |
| Past Shade Open Switch Stuck ON | Roof sunshade open switch stuck signal (Past) | OFF or ON | OFF: No roof sunshade switch stuck signal (Past) ON: Roof sunshade switch stuck signal (Past) |
- |
| Current Vent Switch Stuck ON | Sliding roof tilt switch stuck signal (Current) | OFF or ON | OFF: No sliding roof switch stuck signal (Current) ON: Sliding roof switch stuck signal (Current) |
- |
| Past Vent Switch Stuck ON | Sliding roof tilt switch stuck signal (Past) | OFF or ON | OFF: No sliding roof switch stuck signal (Past) ON: Sliding roof switch stuck signal (Past) |
- |
| Number of Trouble Codes | Number of trouble codes | Min.: 0 to Max.: 255 | Number of DTCs is displayed | - |
*: w/o Canister Pump Module
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| Hall IC1 Status | Status of Hall IC1 | Normal or Error | Normal: Hall IC1 normal Error: Hall IC1 not normal |
- |
| Hall IC1 Pulse | Hall IC1 pulse output | Lo or Hi | Lo and Hi repeat during motor operation | Lo: Hall IC1 output is low Hi: Hall IC1 output is high |
| Hall IC2 Status | Status of Hall IC2 | Normal or Error | Normal: Hall IC2 normal Error: Hall IC2 not normal |
- |
| Hall IC2 Pulse | Hall IC2 pulse output | Lo or Hi | Lo and Hi repeat during motor operation | Lo: Hall IC2 output is low Hi: Hall IC2 output is high |
| Ignition (MPX) | Engine switch signal (LIN signal) | OFF or ON | OFF: Engine switch off ON: Engine switch on (IG) |
- |
| Ignition (Direct Signal) | Engine switch signal | OFF or ON | OFF: Engine switch off ON: Engine switch on (IG) |
- |
| Key Off Permission | Key-off sliding roof operation permit signal | OFF or ON | OFF: Any status except "ON" status ON: Front doors are not opened within 45 seconds after engine switch turned off |
- |
| Vent Switch | Sliding roof tilt switch signal | OFF or ON | OFF: Sliding roof switch not pressed ON: Sliding roof switch pressed |
- |
| Roof Open Switch | Sliding roof open switch signal | OFF or ON | OFF: Sliding roof switch not slid backward ON: Sliding roof switch slid backward |
- |
| Roof Close Switch | Sliding roof close switch signal | OFF or ON | OFF: Sliding roof switch not slid forward ON: Sliding roof switch slid forward |
- |
| Shade Close Switch | Roof sunshade close switch signal | OFF or ON | OFF: Roof sunshade switch not slid forward ON: Roof sunshade switch slid forward |
- |
| Shade Open Switch | Roof sunshade open switch signal | OFF or ON | OFF: Roof sunshade switch not slid backward ON: Roof sunshade switch slid backward |
- |
| Current Roof Open Switch Stuck ON | Sliding roof open switch stuck signal (Current) | OFF or ON | OFF: No sliding roof switch stuck signal (Current) ON: Sliding roof switch stuck signal (Current) |
- |
| Current Roof Close Switch Stuck ON | Sliding roof close switch stuck signal (Current) | OFF or ON | OFF: No sliding roof switch stuck signal (Current) ON: Sliding roof switch stuck signal (Current) |
- |
| Current Shade Close Switch Stuck ON | Roof sunshade close switch stuck signal (Current) | OFF or ON | OFF: No roof sunshade switch stuck signal (Current) ON: Roof sunshade switch stuck signal (Current) |
- |
| Current Shade Open Switch Stuck ON | Roof sunshade open switch stuck signal (Current) | OFF or ON | OFF: No roof sunshade switch stuck signal (Current) ON: Roof sunshade switch stuck signal (Current) |
- |
| Past Roof Open Switch Stuck ON | Sliding roof open switch stuck signal (Past) | OFF or ON | OFF: No sliding roof switch stuck signal (Past) ON: Sliding roof switch stuck signal (Past) |
- |
| Past Roof Close Switch Stuck ON | Sliding roof close switch stuck signal (Past) | OFF or ON | OFF: No sliding roof switch stuck signal (Past) ON: Sliding roof switch stuck signal (Past) |
- |
| Past Shade Close Switch Stuck ON | Roof sunshade close switch stuck signal (Past) | OFF or ON | OFF: No roof sunshade switch stuck signal (Past) ON: Roof sunshade switch stuck signal (Past) |
- |
| Past Shade Open Switch Stuck ON | Roof sunshade open switch stuck signal (Past) | OFF or ON | OFF: No roof sunshade switch stuck signal (Past) ON: Roof sunshade switch stuck signal (Past) |
- |
| Current Vent Switch Stuck ON | Sliding roof tilt switch stuck signal (Current) | OFF or ON | OFF: No sliding roof switch stuck signal (Current) ON: Sliding roof switch stuck signal (Current) |
- |
| Past Vent Switch Stuck ON | Sliding roof tilt switch stuck signal (Past) | OFF or ON | OFF: No sliding roof switch stuck signal (Past) ON: Sliding roof switch stuck signal (Past) |
- |
| Number of Trouble Codes | Number of trouble codes | Min.: 0 to Max.: 255 | Number of DTCs is displayed | - |
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| IG SW | Engine switch status | OFF or ON | OFF: Engine switch off ON: Engine switch on (IG) |
"OFF" is displayed even though the engine switch is on (ACC). |
| FR Door Courtesy SW | Front door courtesy light switch assembly (for RH) signal | OFF or ON | OFF: Front door RH closed ON: Front door RH open |
- |
| FL Door Courtesy SW | Front door courtesy light switch assembly (for LH) signal | OFF or ON | OFF: Front door LH closed ON: Front door LH open |
- |
| Slide Roof Open Warning | Sliding roof open warning | OFF or ON | Customize setting displayed | - |
| Communication Slide Roof | Connection status between sliding roof ECU (sliding roof drive gear assembly) and main body ECU (multiplex network body ECU) | STOP or OK | STOP: Communication stopped OK: Normal communication |
- |
| Communication Sliding Sunshade ECU | Connection status between roof sunshade ECU (sliding roof drive gear assembly) and main body ECU (multiplex network body ECU) | STOP or OK | STOP: Communication stopped OK: Normal communication |
- |
| The Number of DTC | Number of trouble codes | Min.: 0 to Max.: 255 | Number of DTCs is displayed | - |
ACTIVE TEST
Tech Tips
Using the GTS to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.
Connect the GTS to the DLC3.
Turn the engine switch on (IG).
Turn the GTS on.
Enter the following menus: Body Electrical / Sliding Roof or Sliding Sunshade / Active Test.
Perform the Active Test according to the display on the GTS.
| Tester Display | Measurement Item | Control Range | Diagnostic Note |
|---|---|---|---|
| Slide Roof | Operate sliding roof motor | OFF / Opn/Dwn / Clos/Up | - |
| Tester Display | Measurement Item | Control Range | Diagnostic Note |
|---|---|---|---|
| Sliding Sunshade | Operate roof sunshade | OFF / Open / Close | - |