POWER BACK DOOR SYSTEM PRECAUTION


  1. PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable from the negative (-) battery terminal, initialize the following systems after the cable is reconnected.

    System Name See Procedure
    LKA/LDA System

    Click here

    Stop and Start System
    Intelligent Clearance Sonar System
    Parking Assist Monitor System (w/ Parallel Parking Assist Function)
    Parking Assist Monitor System (w/o Parallel Parking Assist Function)
    Panoramic View Monitor System
    Power Door Lock Control System
    Pre-Crash Safety System
    Power Back Door System
    Lighting System (EXT)
    Adaptive High Beam System

  2. PRECAUTIONS FOR TOUCHLESS POWER BACK DOOR


    1. In the following situations, the touchless power back door may operate unintentionally if the electrical key transmitter sub-assembly is near or within the rear door exterior detection area:

      Tech Tips

      Refer to Entry and Start System (for Entry Function)

      Click here


      • When a large amount of water is applied to the rear emblem sensor assembly, such as when in heavy rain.

      • When water is applied to the rear emblem sensor assembly, such as when washing the vehicle.

      • When dirt, etc. is wiped off the rear emblem sensor assembly.

      • If a person is leaning toward or against the rear emblem sensor assembly.

      • When a metal object is brought near the rear emblem sensor.

      • When a vehicle cover is installed or removed.

    2. In the following situations, the sensitivity of the rear emblem sensor assembly may decrease and the touchless power back door may not operate normally:


      • When a large amount of water is applied to the rear emblem sensor assembly, such as when in heavy rain.

      • When water is applied to the rear emblem sensor assembly, such as when washing the vehicle.

      • For a few seconds after dirt, etc. is wiped off the rear emblem sensor assembly.

      • When mud, snow, ice, etc. is attached to the rear emblem sensor assembly.

      • When the vehicle has been parked for a while near objects that move and contact the emblem sensor, such as tall grass or trees.

      • When a device which emits radio waves which are near the same frequency as the rear emblem sensor assembly is near the vehicle.

    3. In the following situations, the touchless power back door will not operate:


      • When an electrical key transmitter sub-assembly is not detected within the back door exterior detection area.

      • When the back door is not fully closed.

      • When a hand is held parallel to the rear emblem sensor assembly.

      • When the electrical key transmitter sub-assembly is outside of the rear door exterior detection area.

      • When the electrical key transmitter sub-assembly cannot be verified because of wave interference.