SLIDING ROOF SWITCH ASSEMBLY INSPECTION

PROCEDURE


  1. INSPECT SLIDING ROOF SWITCH (MAP LIGHT ASSEMBLY)


    1. A01RDRWC01
      *a

      Component without harness connected

      (Sliding Roof Switch (Map Light Assembly))

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      23 - 19 UP switch pressed Below 100 Ω
      23 - 19 UP switch not pressed 1 kΩ or higher
      24 - 19 DOWN switch pressed Below 100 Ω
      24 - 19 DOWN switch not pressed 1 kΩ or higher
      11 - 19 OPEN switch pressed Below 100 Ω
      11 - 19 OPEN switch not pressed 1 kΩ or higher
      12 - 19 CLOSE switch pressed Below 100 Ω
      12 - 19 CLOSE switch not pressed 1 kΩ or higher

      If the result is not as specified, replace the sliding roof switch (map light assembly).

  2. INSPECT PANORAMIC MOON ROOF SWITCH (MAP LIGHT ASSEMBLY)


    1. A01RDBQC02
      *a

      Component without harness connected

      (Panoramic Moon Roof Switch (Map Light Assembly))

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      11 - 19 Sliding roof switch slid backward Below 100 Ω
      11 - 19 Sliding roof switch not slid backward 1 kΩ or higher
      12 - 19 Sliding roof switch slid forward Below 100 Ω
      12 - 19 Sliding roof switch not slid forward 1 kΩ or higher
      7 - 19 Sliding roof switch pressed Below 100 Ω
      7 - 19 Sliding roof switch not pressed 1 kΩ or higher
      23 - 19 Roof sunshade switch slid backward Below 100 Ω
      23 - 19 Roof sunshade switch not slid backward 1 kΩ or higher
      24 - 19 Roof sunshade switch slid forward Below 100 Ω
      24 - 19 Roof sunshade switch not slid forward 1 kΩ or higher

      If the result is not as specified, replace the sliding roof switch (map light assembly).