SLIDING ROOF HOUSING(for Sliding Roof) REASSEMBLY

PROCEDURE


  1. INSTALL SLIDING ROOF DRIVE CABLE SUB-ASSEMBLY


    1. A01RBMIC01
      B005M6U Hold Position

      Hold down the roof wind deflector panel sub-assembly.

    2. A01RESYC01
      *a Protective Tape
      B005M6U Push Position
      B005OOA Install in this Direction

      Using a screwdriver, slide the sliding roof drive cable LH as shown in the illustration to install it.

      Tech Tips


      • Tape the screwdriver tip before use.

      • Use the same procedure for the RH side.

    3. A01R91BC01
      *a Alignment Mark

      Adjust Fully Closed Position:


      1. Using a screwdriver, slide the sliding roof drive cable LH in either direction and align the alignment marks as shown in the illustration.

        Tech Tips

        Use the same procedure for the RH side.

    4. A01RDA5C01
      B005OOA Install in this Direction

      Insert the rear roof drip channel into the sliding roof housing sub-assembly as shown in the illustration.

    5. Engage the 2 claws as shown in the illustration to install the rear roof drip channel.

      A01RDX2C01
      B005OOA Install in this Direction - -

  2. INSTALL SUNSHADE TRIM SUB-ASSEMBLY


    1. A01R8TWC01
      B005OOA Install in this Direction

      Insert the sunshade trim sub-assembly into the sliding roof housing sub-assembly as shown in the illustration.

    2. A01RETPC01
      B005OOA Install in this Direction

      Install the rear sliding roof sunshade stopper as shown in the illustration.

      Tech Tips

      Use the same procedure for the RH side.

    3. A01RD10C01
      B005OOA Install in this Direction (1)
      B005OMH Install in this Direction (2)

      Engage the 2 guides (A) in the direction indicated by the arrow (1) shown in the illustration.

    4. Engage the guide (B) in the direction indicated by the arrow (2) shown in the illustration.

    5. Install the sliding roof piece sub-assembly LH with the screw.

      Tech Tips

      Use the same procedure for the RH side.

  3. INSTALL SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY


    1. Apply MP grease to the gear of the sliding roof drive gear sub-assembly.

    2. A01RERL

      Install the sliding roof drive gear sub-assembly with the 2 bolts.

      Torque:
      5.4 N*m  { 55 kgf*cm, 48 in.*lbf }
    3. A01RB5CC01
      B005OOA Install in this Direction

      Engage the 2 guides as shown in the illustration.

    4. Install the map light bracket with the bolt.

      Torque:
      5.4 N*m  { 55 kgf*cm, 48 in.*lbf }