| DTC Code | DTC Name |
|---|---|
| B15C6 | Ignition Switch Signal Malfunction |
DESCRIPTION
If vehicle movement (10 km/h (6 mph) or more for 10 seconds) is detected based on the location data sent from the radio receiver assembly even when the telematics transceiver detects that the engine switch is off, this DTC will be stored.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| B15C6 | Ignition Switch Signal Malfunction | IG signal error |
|
WIRING DIAGRAM
CAUTION / NOTICE / HINT
Note
Inspect the fuses for circuits related to this system before performing the following procedure.
Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for G-BOOK.
PROCEDURE
CHECK DTC OUTPUT
Clear the DTCs.
Recheck for DTCs and check if the same DTC is output again.
| Result | ||||||
|---|---|---|---|---|---|---|
|
| A |
|
USE SIMULATION METHOD TO CHECK Click here |
| B |
|
CHECK HARNESS AND CONNECTOR (TELEMATICS TRANSCEIVER POWER SOURCE)
Disconnect the J62 telematics transceiver connector.
Measure the resistance according to the value(s) in the table below.
| Standard Resistance | ||||||
|---|---|---|---|---|---|---|
|
Measure the voltage according to the value(s) in the table below.
| Standard Voltage | ||||||
|---|---|---|---|---|---|---|
|
| Result | |||
|---|---|---|---|
|
| OK |
|
REPLACE TELEMATICS TRANSCEIVER Click here |
| NG |
|
GO TO STOP AND START SYSTEM Click here |