NOISE FILTER(w/ Rear No. 2 Seat) REMOVAL

PROCEDURE

1. REMOVE REAR NO. 2 SEAT ASSEMBLY

   Click here

2. REMOVE REAR DOOR SCUFF PLATE LH

   Click here

3. REMOVE REAR DOOR INSIDE SCUFF PLATE LH

   Click here

4. REMOVE REAR SEAT OUTER TRACK BRACKET COVER LH

   Click here

5. REMOVE FRONT DECK SIDE TRIM COVER LH

   Click here

6. REMOVE REAR SEAT SIDE GARNISH LH

   Click here

7. REMOVE NO. 1 LUGGAGE COMPARTMENT TRIM HOOK

   Click here

8. REMOVE ROPE HOOK ASSEMBLY

   Click here

9. REMOVE NO. 1 LUGGAGE COMPARTMENT LIGHT ASSEMBLY

   Click here

10. REMOVE NO. 2 AIR CONDITIONING CONTROL ASSEMBLY

    Click here

11. REMOVE COOLER (NO. 2 ROOM TEMP. SENSOR) THERMISTOR

    Click here

12. REMOVE DECK TRIM SIDE PANEL ASSEMBLY LH

    Click here

13. REMOVE RADIO SETTING CONDENSER

    Note

    When the terminal cover is removed, the radio setting condenser must be replaced because the terminal cover and condenser are supplied as a set.

    
    

    1. 

       Remove the bolt.

    2. Disengage the clamp and disconnect the radio setting condenser with wire harness from the vehicle body.

    3. 

       Using a screwdriver, disengage the 3 claws and remove the terminal cover with wire harness from the condenser.

    4. 

       Using a screwdriver, bend back and break off the claw as shown in the illustration.

    5. Remove the terminal cover from the wire harness.

       Note

       
       

       • Make sure to hold the crimping side of the terminal when disconnecting the wire harness from the terminal cover.

       • Make sure not to bend the exposed wire when disconnecting the wire harness from the terminal cover.

       • Check for deformation of the terminal after the wire harness has been removed from the terminal cover.