NOISE FILTER(w/ Rear No. 2 Seat) ON-VEHICLE INSPECTION

PROCEDURE


  1. INSPECT RADIO SETTING CONDENSER


    1. With the radio setting condenser installed, check that there is no looseness or other abnormalities.

    2. B005NJQC03
      *a Radio Setting Condenser

      Measure the resistance of the radio setting condenser according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      1 - Body ground

      • Engine switch off

      • Window Defogger turned off

      		 Below 1 Ω

    3. Remove the bolt.

    4. Disengage the 2 clamps and disconnect the radio setting condenser with wire harness from the vehicle body.

    5. B005NTPC30
      *a Radio Setting Condenser

      Measure the resistance and voltage of the radio setting condenser according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      2 - 3

      • Engine switch off

      • Window Defogger turned off

      		 10 kΩ or higher
      Standard Voltage
      Tester Connection Condition Specified Condition
      2 - Body ground

      • Engine switch on (IG)

      • Window Defogger turned off

      		 Below 1 V
      2 - Body ground

      • Engine switch on (IG)

      • Window Defogger turned on

      		 11 to 14 V