REAR SEAT ENTERTAINMENT SYSTEM Display Mode Signal Circuit between Multi-display Controller and Television Display Assembly

DESCRIPTION

This is the display mode signal circuit from the multi-display controller sub-assembly to the television display assembly RH.

WIRING DIAGRAM

B005NOPE06
*a Television Display Assembly RH
*b Multi-display Controller Sub-assembly

PROCEDURE


  1. CHECK HARNESS AND CONNECTOR (MULTI-DISPLAY CONTROLLER SUB-ASSEMBLY - TELEVISION DISPLAY ASSEMBLY RH)


    1. Disconnect the R13 multi-display controller sub-assembly connector.

    2. Disconnect the d5 television display assembly RH connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      R13-9 (MDO) - d5-1 (MDO) Always Below 1 Ω
      R13-9 (MDO) - Body ground Always 10 kΩ or higher
      Result
      Proceed to
      OK
      NG

    OK

    PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Click here

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR