REAR SEAT ENTERTAINMENT SYSTEM Visual Mute Signal Circuit between Navigation Receiver Assembly and Multi-display Controller

DESCRIPTION

This is the visual mute signal circuit from the radio receiver assembly to the multi-display controller sub-assembly.

WIRING DIAGRAM

B005NOPE03
*1 Multi-display Controller Sub-assembly
*2 Radio Receiver Assembly

PROCEDURE


  1. INSPECT RADIO RECEIVER ASSEMBLY

    B005QA0C43
    *a

    Component with harness connected

    (Radio Receiver Assembly)

    1. Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Condition Specified Condition
      J50-9 (VMTR) - Body ground

      RSE playing

      → Source changed

      Above 3.5 V

      → Below 1 V
      Result
      Proceed to
      OK
      NG

    OK

    PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Click here

    NG

  2. CHECK HARNESS AND CONNECTOR (MULTI-DISPLAY CONTROLLER SUB-ASSEMBLY - RADIO RECEIVER ASSEMBLY)


    1. Disconnect the J50 radio receiver assembly connector.

    2. Disconnect the R13 multi-display controller sub-assembly connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      J50-9 (VMTR) - R13-8 (VMTR) Always Below 1 Ω
      J50-9 (VMTR) - Body ground Always 10 kΩ or higher
      Result
      Proceed to
      OK
      NG

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

  3. INSPECT RADIO RECEIVER ASSEMBLY


    1. B005PZ1C02
      *a

      Front view of wire harness connector

      (to Multi-display Controller Sub-assembly)

      Reconnect the J50 radio receiver assembly connector.

    2. Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Condition Specified Condition
      R13-8 (VMTR) - Body ground Television display assembly ON Above 3.5 V
      Result
      Proceed to
      OK
      NG

    OK

    REPLACE MULTI-DISPLAY CONTROLLER SUB-ASSEMBLY Click here

    NG

    REPLACE RADIO RECEIVER ASSEMBLY Click here