STEERING COLUMN ASSEMBLY REASSEMBLY

CAUTION / NOTICE / HINT

Note


  • Do not drop the power steering ECU assembly, strike it with tools or subject it to impacts.

  • If the power steering ECU assembly is subjected to an impact, replace it with a new one.

  • Do not pull the wire harness.

  • Do not allow any moisture to come into contact with the power steering ECU assembly.

  • Do not loosen any bolts not mentioned in the procedure.

  • Do not allow any foreign matter to contaminate the power steering ECU assembly.

PROCEDURE


  1. INSTALL POWER STEERING ECU ASSEMBLY

    Click here

  2. INSTALL MULTIPLEX TILT AND TELESCOPIC ECU


    1. A01R8TD

      Engage the claw to install the multiplex tilt and telescopic ECU.

  3. INSTALL STEERING LOCK ACTUATOR OR UPPER BRACKET ASSEMBLY

    Tech Tips

    When replacing the steering lock actuator or upper bracket assembly, refer to Service Bulletin.


    1. Secure the steering column assembly in a vise between aluminum plates and cloths.

      Note

      Do not overtighten the vise.

    2. A01RDC4

      Temporarily install the steering lock actuator or upper bracket assembly with 2 new steering lock set bolts.

    3. Tighten the 2 steering lock set bolts until the bolt head breaks off.