STEERING WHEEL INSTALLATION

CAUTION / NOTICE / HINT

Note


  • Do not replace the spiral cable with sensor sub-assembly with the battery connected and the engine switch on (IG).

  • Do not rotate the spiral cable with sensor sub-assembly without the steering wheel assembly installed, with the battery connected and the engine switch on (IG).

  • Ensure that the steering wheel assembly is installed and aligned straight when inspecting the steering sensor.

PROCEDURE


  1. INSTALL NO. 1 SWITCH WIRE (w/ Shift Paddle Switch)

    U661F: Click here

    U881F: Click here

  2. INSTALL SHIFT PADDLE SWITCH (TRANSMISSION SHIFT SWITCH ASSEMBLY) (w/ Shift Paddle Switch)

    U661F: Click here

    U881F: Click here

  3. INSTALL LOWER NO. 1 STEERING WHEEL BOSS COVER (w/ Shift Paddle Switch)

    U661F: Click here

    U881F: Click here

  4. INSTALL STEERING PAD SWITCH ASSEMBLY

    Click here

  5. INSTALL CRUISE CONTROL MAIN SWITCH

    Click here

  6. ALIGN FRONT WHEELS FACING STRAIGHT AHEAD

  7. INSPECT AND ADJUST SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY

    Click here

  8. INSTALL STEERING WHEEL ASSEMBLY


    1. A01VUZ2C01
      *a Matchmark

      Align the matchmarks on the steering wheel assembly and steering main shaft to install the steering wheel assembly.

    2. Install the steering wheel assembly set nut.

      Torque:
      50 N*m  { 510 kgf*cm, 37 ft.*lbf }

    3. Connect each connector to the spiral cable with sensor sub-assembly.

  9. CHECK STEERING WHEEL CENTER POINT

  10. INSTALL HORN BUTTON ASSEMBLY

    Click here