POWER STEERING SYSTEM, Diagnostic DTC:C1552, C1554

DTC Code DTC Name
C1552 PIG Power Supply Voltage
C1554 Power Supply Relay Failure

DESCRIPTION

If a problem occurs in the system, the power source relay circuit and the motor relay circuit are shut off to stop power assist. The ECU must be replaced when there is a problem with the relays because the relays are built into the ECU.

DTC No. Detection Item DTC Detection Condition Trouble Area Warning Indicate Return-to-normal Condition Note
C1552 PIG Power Supply Voltage PIG power source circuit malfunction

  • EPS fuse

  • PIG power source circuit

  • Power steering ECU assembly

 EPS warning light: Comes on Engine switch on (IG) again -
C1554 Power Supply Relay Failure Power source relay circuit malfunction

  • EPS fuse

  • PIG power source circuit

  • Power steering ECU assembly

 EPS warning light: Comes on Engine switch on (IG) again -

WIRING DIAGRAM

A01VXHLE09
*a from Battery
*b Power Steering ECU Assembly

CAUTION / NOTICE / HINT

Note


  • If the power steering ECU assembly has been replaced, perform assist map writing and torque sensor zero point calibration.

    Click here

  • Inspect the fuses for circuits related to this system before performing the following procedure.

PROCEDURE


  1. CHECK HARNESS AND CONNECTOR (POWER STEERING ECU ASSEMBLY - BODY GROUND)


    1. Disconnect the J5 power steering ECU assembly connectors.

    2. Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Condition Specified Condition
      J5-1 (PIG) - Body ground Engine switch on (IG) 9 to 16 V
    3. A01VV6FC08
      *a

      Front view of wire harness connector

      (to Power Steering ECU Assembly)

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      J5-2 (PGND) - Body ground Always Below 1 Ω
      Result
      Proceed to
      OK
      NG

    OK

    REPLACE POWER STEERING ECU ASSEMBLY Click here

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR