ELECTRIC PARKING BRAKE ACTUATOR REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The following procedure is for the LH side.

PROCEDURE


  1. PRECAUTION

    Click here

  2. RELEASE PARKING BRAKE


    1. Move the shift lever to P.

    2. Turn the engine switch on (IG).

    3. Operate the electric parking brake switch assembly to release the parking brake.

      Tech Tips

      If the parking brake cannot be released:

      Click here

    4. Turn the engine switch off.

  3. REMOVE REAR WHEEL

    Click here

  4. DISCONNECT NO. 2 PARKING BRAKE WIRE ASSEMBLY


    1. B005N4K

      Disconnect the No. 2 parking brake wire assembly connector from the parking brake actuator assembly LH.

      Note


      • Remove any dirt or foreign matter on and around the connector before performing this work.

      • Do not allow water, oil or dirt to enter the connector.

  5. REMOVE PARKING BRAKE ACTUATOR ASSEMBLY LH


    1. B005MYG

      Using a 5 mm hexagon socket wrench, remove the 2 bolts and parking brake actuator assembly LH from the rear disc brake cylinder assembly LH.

      Note


      • Check that there are no brake fluid leaks from the back of the rear disc brake cylinder assembly.

      • If there are any brake fluid leaks, replace the rear disc brake cylinder assembly.

    2. Remove the O-ring from the rear disc brake cylinder assembly LH.