REAR DISC BRAKE PAD REPLACEMENT

CAUTION / NOTICE / HINT

Note

After replacing the rear disc brake pads, the brake pedal may feel soft due to clearance between the rear disc brake pads and rear disc. Depress the brake pedal several times until the brake pedal feels firm.

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The following procedure is for the LH side.

PROCEDURE


  1. PRECAUTION

    Click here

  2. PERFORM REAR BRAKE PAD REPLACEMENT MODE

    Click here

  3. REMOVE REAR WHEEL

    Click here

  4. SEPARATE REAR FLEXIBLE HOSE


    1. B005MNY

      Remove the bolt and separate the rear flexible hose.

  5. DISCONNECT NO. 2 PARKING BRAKE WIRE ASSEMBLY

    Click here

  6. SEPARATE REAR DISC BRAKE CYLINDER ASSEMBLY


    1. B005OJVC01
      *a Turn
      *b Hold

      Hold the 2 rear disc brake cylinder slide pins and remove the 2 bolts and separate the rear disc brake cylinder assembly.

  7. REMOVE REAR DISC BRAKE PAD

    CAUTION:

    Be careful not to get pinched by the rear disc brake cylinder assembly or other parts when removing the rear disc brake pads.


    1. B005LOU

      Remove the 2 rear disc brake pads from the rear disc brake cylinder mounting.

  8. REMOVE REAR DISC BRAKE ANTI-SQUEAL SHIM

    Click here

  9. INSTALL REAR DISC BRAKE ANTI-SQUEAL SHIM

    Click here

  10. INSTALL REAR DISC BRAKE PAD

    CAUTION:

    Be careful not to get pinched by the rear disc brake cylinder assembly or other parts when installing the rear disc brake pads.


    1. B005PUW

      Using SST, push in the rear disc brake piston.

      SST
      09719-77010

      Note


      • Make sure the brake fluid does not overflow from the reservoir.

      • Do not forcibly push in the rear disc brake piston.

    2. Install the 2 rear disc brake pads to the rear disc brake cylinder mounting.

      Note

      Install the rear disc brake pad so that the rear disc brake pad wear indicator plate is mounted on the lower side of the vehicle.

      Tech Tips

      If the rear disc brake pad has an identification mark, be sure to confirm the installation location.

      B005LXYC01
      *a Inner Side (Light Blue)
      *b Outer Side (Pink)

  11. INSTALL REAR DISC BRAKE CYLINDER ASSEMBLY


    1. Hold the 2 rear disc brake cylinder slide pins, and install the rear disc brake cylinder assembly to the rear disc brake cylinder mounting with 2 new bolts.

      Torque:
      34.3 N*m  { 350 kgf*cm, 25 ft.*lbf }

  12. CONNECT NO. 2 PARKING BRAKE WIRE ASSEMBLY

    Click here

  13. INSTALL REAR FLEXIBLE HOSE


    1. Install the rear flexible hose with the bolt.

      Torque:
      18.8 N*m  { 192 kgf*cm, 14 ft.*lbf }

  14. INSPECT BRAKE FLUID LEVEL IN RESERVOIR

    Click here

  15. INSTALL REAR WHEEL

    Click here

  16. NORMAL CONDITION RECOVERY

    Click here