VACUUM PUMP(for 2GR-FKS) ON-VEHICLE INSPECTION

PROCEDURE


  1. REMOVE FRONT WIPER MOTOR AND LINK ASSEMBLY

    Click here

  2. REMOVE OUTER COWL TOP PANEL SUB-ASSEMBLY

    for LHD: Click here

    for RHD: Click here

  3. OPERATION CHECK


    1. Slide the clip and disconnect the air tube from the vacuum pump assembly.

    2. A01VVEDC01
      *a Vacuum Gauge
      *b Plug

      Connect the hose of the vacuum gauge to the vacuum pump assembly.

    3. Start the engine and warm it up for more than 2 minutes.

    4. With the engine idling, check the vacuum of the vacuum pump assembly.

      Standard Pressure
      More than 86.7 kPa (650 mmHg, 25.6 in.Hg)

      If the pressure is less than the standard, disassemble and inspect the vacuum pump. If necessary, replace the vacuum pump assembly.

      Click here

      Tech Tips

      Always perform this operation check procedure after replacing or servicing the vacuum pump assembly.

    5. Remove the vacuum gauge from the vacuum pump assembly.

    6. Connect the air tube to the vacuum pump assembly, and slide the clip to secure it.

  4. INSTALL OUTER COWL TOP PANEL SUB-ASSEMBLY

    for LHD: Click here

    for RHD: Click here

  5. INSTALL FRONT WIPER MOTOR AND LINK ASSEMBLY

    Click here