INTELLIGENT CLEARANCE SONAR SYSTEM, Diagnostic DTC:C1AF9

DTC Code DTC Name
C1AF9 Blind Spot Monitor Beam Axis Inspection Incomplete

DESCRIPTION

This DTC is stored when the clearance warning ECU assembly receives a signal from the blind spot monitor system via CAN communication indicating that the beam axis inspection is incomplete.

DTC No. Detection Item DTC Detection Condition Trouble Area
C1AF9 Blind Spot Monitor Beam Axis Inspection Incomplete The clearance warning ECU assembly receives a signal indicating that the beam axis inspection is incomplete. Blind spot monitor system

PROCEDURE


  1. CHECK FOR DTC


    1. Using the GTS, check for DTCs according to the prompts on the screen.

      Click here

      Tech Tips

      After turning the engine switch from off to on (IG), wait 4 seconds or more before checking for DTCs.


      Body Electrical > IPA/ICS/Clearance Sonar > Trouble Codes

    2. Clear the DTCs according to the screen on the GTS.

      Click here


      Body Electrical > IPA/ICS/Clearance Sonar > Clear DTCs

    3. Recheck for DTCs.

      Click here


      Body Electrical > IPA/ICS/Clearance Sonar > Trouble Codes

      Tech Tips


      • DTC C1AF9 is stored when a malfunction signal sent from the blind spot monitor system is detected.

      • If the malfunctioning part has been repaired or replaced before rechecking for DTCs, DTC C1AF9 will not be output again.

      • If DTC C1AF9 is output frequently, duplicate the conditions that cause the problem symptoms and perform the inspection again, even though the DTC was not output when rechecking for DTCs.

        Click here

      Result
      Result Proceed to
      DTC C1AF9 is output A
      DTC C1AF9 is not output B

    A

    GO TO BLIND SPOT MONITOR SYSTEM Click here

    B

    USE SIMULATION METHOD TO CHECK Click here