PROPELLER SHAFT ASSEMBLY COMPONENTS
ILLUSTRATION
| *A | for Front Side | *B | for Rear Side |
| *C | for 8AR-FTS | *D | for 2GR-FKS |
| *1 | FRONT CENTER FLOOR COVER | *2 | FRONT FLOOR COVER LH |
| *3 | NO. 2 ENGINE UNDER COVER | *4 | PROPELLER SHAFT GUARD |
| *5 | WIRING HARNESS CLAMP BRACKET | - | - |
 |
N*m (kgf*cm, ft.*lbf): Specified torque | - | - |
ILLUSTRATION
| *1 | PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY | *2 | CENTER NO. 2 SUPPORT BEARING WASHER |
 |
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping" : N*m (kgf*cm, ft.*lbf) | |
N*m (kgf*cm, ft.*lbf): Specified torque |
 |
Do not apply lubricants | - | - |
ILLUSTRATION
| *A | for Front Side | *B | for Rear Side |
| *1 | CENTER NO. 2 SUPPORT BEARING ASSEMBLY | *2 | INTERMEDIATE SHAFT ASSEMBLY |
| *3 | PROPELLER SHAFT ASSEMBLY | *4 | REAR PROPELLER SHAFT ASSEMBLY |
| *5 | UNIVERSAL JOINT FLANGE | *6 | UNIVERSAL JOINT WASHER |
| *7 | WASHER | - | - |
| |
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping" : N*m (kgf*cm, ft.*lbf) | |
N*m (kgf*cm, ft.*lbf): Specified torque |
| ● | Non-reusable part | |
Do not apply lubricants |
| *T1 | 1st: 181.5 (1851, 134) 2nd: 68.7 (701, 51) |
- | - |