REAR DRIVE SHAFT ASSEMBLY INSPECTION

PROCEDURE


  1. INSPECT REAR DRIVE SHAFT ASSEMBLY


    1. A01RCE1

      Check that there is no excessive play in the radial direction of the outboard joint.

    2. Check that the inboard joint slides smoothly in the thrust direction.

    3. Check that there is no excessive play in the radial direction of the inboard joint.

    4. Check the boots for damage.

    5. B005MZNN46

      Check whether each drive shaft dimension (A) is within specification.

      Note

      Keep the drive shaft assembly level during inspection.

      Dimension (A)
      for LH Side 753.25 to 763.25 mm (2.48 to 2.50 ft.)
      for RH Side 733.25 to 743.25 mm (2.41 to 2.43 ft.)