4WD CONTROL SWITCH(for 8AR-FTS) INSPECTION

PROCEDURE


  1. INSPECT AWD LOCK SWITCH (INTEGRATION CONTROL AND PANEL ASSEMBLY)


    1. A01RET6C01
      *a

      Component without harness connected

      (AWD Lock Switch (Integration Control and Panel Assembly))

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      6 (+B) - 18 (GND) AWD lock switch pushed Below 100 Ω
      AWD lock switch not pushed 1 MΩ or higher

      If the result is not as specified, replace the AWD lock switch (integration control and panel assembly).

    2. A01RET6C02
      *a

      Component without harness connected

      (AWD Lock Switch (Integration Control and Panel Assembly))

      Apply battery voltage between the terminals of the switch, and check the illumination condition of the AWD lock switch (integration control and panel assembly).

      Standard
      Measurement Condition Specified Condition

      Battery positive (+) → Terminal 8 (ILL+)

      Battery negative (-) → Terminal 15 (ILL-)

      		 Illuminates

      If the result is not as specified, replace the AWD lock switch (integration control and panel assembly).