TRANSFER CASE REAR OIL SEAL REPLACEMENT

PROCEDURE


  1. REMOVE PROPELLER SHAFT WITH CENTER BEARING ASSEMBLY

    Click here

  2. REMOVE TRANSFER EXTENSION HOUSING TYPE T OIL SEAL


    1. A01R8WGC02
      *1 Transfer Extension Housing Type T Oil Seal

      Using SST, remove the transfer extension housing type T oil seal from the transfer extension housing sub-assembly.

      SST
      09308-00010

      Note

      Be careful not to damage the transfer extension housing type T oil seal contact surface or the inside surface of the transfer extension housing type T oil seal.

  3. INSTALL TRANSFER EXTENSION HOUSING TYPE T OIL SEAL


    1. A01RE40C01
      *1 Transfer Extension Housing Type T Oil Seal
      *a Depth

      Using SST and a hammer, install a new transfer extension housing type T oil seal to the transfer extension housing sub-assembly until it reaches the position shown in the illustration.

      SST
      09325-20010
      Standard Depth
      9.8 to 10.6 mm (0.386 to 0.417 in.)

      Note


      • Do not tilt the transfer extension housing type T oil seal during installation.

      • Do not tap in the transfer extension housing type T oil seal in too far.

    2. Apply a small amount of MP grease to the lip of the transfer extension housing type T oil seal.

  4. INSTALL PROPELLER SHAFT WITH CENTER BEARING ASSEMBLY

    Click here