PARK / NEUTRAL POSITION SWITCH ADJUSTMENT

PROCEDURE


  1. SECURE VEHICLE


    1. Fully apply the parking brake and chock a wheel.

      CAUTION:


      • Make sure to apply the parking brake and chock a wheel before performing this procedure.

      • If the vehicle is not secure and the shift lever is moved to N, the vehicle may suddenly move, possibly resulting in an accident or serious injury.

      B005NUY

  2. REMOVE COOL AIR INTAKE DUCT SEAL

    Click here

  3. REMOVE INLET AIR CLEANER ASSEMBLY

    Click here

  4. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  5. REMOVE BATTERY

    Click here

  6. DISCONNECT TRANSMISSION CONTROL CABLE ASSEMBLY

    Click here

  7. ADJUST PARK/NEUTRAL POSITION SWITCH ASSEMBLY


    1. B005LST

      Disconnect the park/neutral position switch assembly connector.

    2. Remove the nut and transmission control shaft lever from the manual valve lever shaft sub-assembly.

    3. B005MXW

      Loosen the 2 bolts of the park/neutral position switch assembly.

    4. B005MXMC01
      *a Neutral Basic Line
      *b Protrusion

      Align the protrusion with the neutral basic line.

    5. Hold the park/neutral position switch assembly in position and tighten the 2 bolts.

      Torque:
      5.4 N*m  { 55 kgf*cm, 48 in.*lbf }

    6. Install the transmission control shaft lever to the manual valve lever shaft sub-assembly with the nut.

      Torque:
      16 N*m  { 163 kgf*cm, 12 ft.*lbf }

    7. Connect the park/neutral position switch assembly connector.

  8. CONNECT TRANSMISSION CONTROL CABLE ASSEMBLY

    Click here

  9. INSTALL BATTERY

    Click here

  10. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  11. INSTALL INLET AIR CLEANER ASSEMBLY

    Click here

  12. INSTALL COOL AIR INTAKE DUCT SEAL

    Click here

  13. INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY OPERATION

    Click here