TRANSMISSION CONTROL CABLE ADJUSTMENT

CAUTION / NOTICE / HINT

Note

Before installing the transmission control cable assembly, check that the park/neutral position switch assembly and the shift lever are in neutral.

PROCEDURE


  1. SECURE VEHICLE


    1. Fully apply the parking brake and chock a wheel.

      CAUTION:


      • Make sure to apply the parking brake and chock a wheel before performing this procedure.

      • If the vehicle is not secure and the shift lever is moved to N, the vehicle may suddenly move, possibly resulting in an accident or serious injury.

      B005NUY

  2. REMOVE CONSOLE BOX ASSEMBLY

    Click here

  3. REMOVE FRONT NO. 1 CONSOLE BOX INSERT

    Click here

  4. ADJUST SHIFT LEVER POSITION


    1. Move the shift lever to N.

    2. B005NLV

      Disconnect the transmission control cable assembly from the transmission floor shift assembly.

    3. B005OP7

      Disengage the 2 claws and disconnect the transmission control cable assembly from the transmission floor shift assembly.

    4. B005LQJC31
      *a Slider
      *b Lock Piece
      *c Slide
      *d Pull

      Slide the slider of the transmission control cable assembly and pull the lock piece outward as shown in the illustration.

    5. Engage the 2 claws to connect the transmission control cable assembly to the transmission floor shift assembly.

      Note

      Make sure that the transmission control cable assembly is securely connected.

    6. B005MHOC01
      *a Lock Piece
      *b Adjuster Case

      Connect the transmission control cable assembly to the transmission floor shift assembly.

      Note


      • Check that the lock piece is pulled out.

      • Push the end of the transmission control cable assembly all the way to the base of the transmission floor shift assembly pin.

      • Connect the transmission control cable assembly so that the lock piece faces the driver side.

    7. B005MYVC01
      *a Lock Piece
      *b Push in
      *c Adjuster Case

      Push the lock piece into the adjuster case.

      Note


      • Make sure that the park/neutral position switch assembly and the shift lever are in neutral.

      • Securely push in the lock piece until the slider lock is engaged.

    8. After adjusting the shift lever position, check the position and operation of the shift lever. If there is a problem, adjust the shift lever position again.

  5. INSTALL FRONT NO. 1 CONSOLE BOX INSERT

    Click here

  6. INSTALL CONSOLE BOX ASSEMBLY

    Click here