PARK / NEUTRAL POSITION SWITCH REMOVAL

PROCEDURE


  1. SECURE VEHICLE


    1. Fully apply the parking brake and chock a wheel.

      CAUTION:


      • Make sure to apply the parking brake and chock a wheel before performing this procedure.

      • If the vehicle is not secure and the shift lever is moved to N, the vehicle may suddenly move, possibly resulting in an accident or serious injury.

      B005NUY

  2. REMOVE AIR CLEANER CAP WITH AIR CLEANER HOSE

    Click here

  3. REMOVE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY

    Click here

  4. REMOVE AIR CLEANER CASE SUB-ASSEMBLY

    Click here

  5. REMOVE AIR CLEANER BRACKET

    Click here

  6. DISCONNECT TRANSMISSION CONTROL CABLE ASSEMBLY


    1. Move the shift lever to N.

    2. B005L53

      Remove the nut and disconnect the transmission control cable assembly from the transmission control shaft lever.

  7. REMOVE PARK/NEUTRAL POSITION SWITCH ASSEMBLY


    1. A01VVQ1

      Disconnect the park/neutral position switch assembly connector.

    2. A01VW2O

      Remove the nut, washer and transmission control shaft lever from the park/neutral position switch assembly.

    3. A01VY1S

      Remove the 2 bolts and park/neutral position switch assembly from the transaxle case sub-assembly.

      Note

      Before removing the park/neutral position switch assembly, remove any dirt or rust on the installation portion of the manual valve lever shaft sub-assembly. Be sure to remove the park/neutral position switch assembly straight along the manual valve lever shaft sub-assembly while being careful not to deform the plate spring that supports the manual valve lever shaft sub-assembly. If the plate spring is deformed, the park/neutral position switch assembly cannot be reinstalled correctly.