COMBINATION SWITCH INSPECTION

PROCEDURE


  1. INSPECT COMBINATION SWITCH ASSEMBLY


    1. Inspect the NORMAL or NORMAL CUSTOMIZE mode switch:


      1. B005PJOC28
        *a

        Component without harness connected

        (Combination Switch Assembly)

        Measure the resistance according to the value(s) in the table below.

        Standard Resistance
        Tester Connection Condition Specified Condition
        8 (B) - 1 (GND) Combination switch pushed and held Below 50 Ω
        Combination switch not pushed 10 kΩ or higher

        If the result is not as specified, replace the combination switch assembly.

    2. Inspect the SPORT or SPORT S/S+ mode switch:


      1. A01R8MYC29
        *a

        Component without harness connected

        (Combination Switch Assembly)

        Measure the resistance according to the value(s) in the table below.

        Standard Resistance
        Tester Connection Condition Specified Condition
        7 (P) - 1 (GND) Combination switch turned and held at SPORT or SPORT S/S+ position Below 50 Ω
        Combination switch not turned 10 kΩ or higher

        If the result is not as specified, replace the combination switch assembly.

    3. Inspect the illumination:


      1. A01R8MYC30
        *a

        Component without harness connected

        (Combination Switch Assembly)

        Apply battery voltage to the combination switch assembly and check that the combination switch assembly illuminates.

        Standard
        Measurement Condition Specified Condition

        Battery positive (+) → Terminal 10 (ILL+)

        Battery negative (-) → Terminal 6 (ILL-)

        		 Illuminates

        If the result is not as specified, replace the combination switch assembly.