SHIFT LEVER INSTALLATION

PROCEDURE


  1. INSTALL TRANSMISSION FLOOR SHIFT ASSEMBLY

    Note

    Check that the park/neutral position switch assembly and the shift lever are in neutral.


    1. B005O5UN01

      Temporarily install the transmission floor shift assembly to the vehicle body with the 4 bolts.

    2. Tighten the 4 bolts in the order shown in the illustration.

      Torque:
      12 N*m  { 122 kgf*cm, 9 ft.*lbf }

  2. CONNECT TRANSMISSION CONTROL CABLE ASSEMBLY


    1. Engage the 2 claws to connect the transmission control cable assembly to the transmission floor shift assembly.

      Note

      Make sure that the transmission control cable assembly is securely connected.

    2. B005PTM

      Connect the transmission control cable assembly to the transmission floor shift assembly.

      Note


      • The shift lever should be in N.

      • Push the end of the transmission control cable assembly all the way to the base of the transmission floor shift assembly pin.

      • Connect the transmission control cable assembly so that the lock piece faces the driver side.

  3. CONNECT WIRE HARNESS


    1. Engage the 3 clamps to connect the wire harness to the transmission floor shift assembly.

    2. Connect the shift lock control ECU connector.

    3. Connect the transmission control switch connector.

  4. INSTALL FRONT NO. 1 CONSOLE BOX INSERT

    Click here

  5. INSTALL CONSOLE BOX ASSEMBLY

    Click here

  6. INSTALL SHIFT LOCK RELEASE BUTTON COVER


    1. B005L67C01
      *a Groove

      Engage the 2 claws to install the shift lock release button cover to the shift position indicator.

      Note

      Install the shift lock release button cover with its groove facing the rear of the vehicle.

  7. INSPECT SHIFT LEVER POSITION

    Click here