MILLIMETER WAVE RADAR SENSOR REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after replaced the millimeter wave radar sensor assembly are shown below.

Necessary procedure after parts removed/installed/replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Millimeter wave radar sensor assembly Adjust millimeter wave radar sensor assembly

  • Dynamic radar cruise control system

  • Pre-crash safety system

  • Forward recognition camera system

  • LKA/LDA system

Click here

PROCEDURE


  1. REMOVE COOL AIR INTAKE DUCT SEAL

    Click here

  2. REMOVE MILLIMETER WAVE RADAR SENSOR ASSEMBLY


    1. A01VUXP

      Disconnect the connector.

    2. A01VWOFC01
      B005NIZ Bolt
      B005LWS Screw

      Remove the 2 bolts and 2 screws.

    3. Disengage the 2 guides and remove the millimeter wave radar sensor assembly.

      Note

      Do not reuse the millimeter wave radar sensor assembly if it has been dropped or subjected to a severe impact.