FRONT CAMERA REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after replaced the front camera are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Forward recognition camera Adjust forward recognition camera

  • Dynamic radar cruise control system

  • Pre-crash safety system

  • Forward recognition camera system

  • LKA/LDA system

  • Road sign assist system

  • Adaptive high beam system

  • Automatic high beam system

Click here

Note


  • When replacing the forward recognition camera, replace it with a new one.

  • Do not touch the camera lens or the front windshield glass in front of the camera.

  • If the forward recognition camera has been struck or dropped, replace it with a new one.

  • When replacing the windshield glass of a vehicle equipped with a forward recognition camera, make sure to use a Lexus genuine part. If a non-Lexus genuine part is used, the forward recognition camera may not be able to be installed due to a missing bracket. Also, the LKA/LDA system, forward recognition camera system, dynamic radar cruise control system, pre-crash safety system, automatic high beam system, adaptive high beam system or road sign assist system may not operate properly due to a difference in the transmissivity or black ceramic border.

PROCEDURE


  1. REMOVE NO. 2 FORWARD RECOGNITION COVER


    1. A01RCXDC01
      B005OOA Remove in this Direction (1)
      B005OMH Remove in this Direction (2)

      Disengage the 2 claws and 2 guides to remove the No. 2 forward recognition cover as shown in the illustration.

      Note

      If these claws are disengaged separately, they may break. Insert a molding remover between them and pull it down to disengage the claws simultaneously.

  2. REMOVE NO. 1 FORWARD RECOGNITION COVER


    1. A01R8QUC01
      B005OOA Remove in this Direction

      Disengage the 2 clips and 2 guides to remove the No. 1 forward recognition cover as shown in theillustration.

      Note

      To avoid damaging the guides, always slide the No. 1 forward recognition cover parallel to the windshield glass.

  3. REMOVE FORWARD RECOGNITION LATCH


    1. A01REIFC01
      B005OOA Remove in this Direction (1)
      B005OMH Remove in this Direction (2)

      Disengage the 2 claws in the direction indicated by the arrow (1) in the illustration.

    2. Disengage the 4 guides in the direction indicated by the arrow (2) in the illustration to remove the forward recognition latch.

  4. REMOVE FORWARD RECOGNITION CAMERA


    1. A01RFDOC01
      B005OOA Remove in this Direction

      Disconnect the connector.

    2. Disengage the 4 guides and remove the forward recognition camera as shown in the illustration.

      Note


      • Do not pull the harness forcibly when disconnecting the connector.

      • If the forward recognition camera bracket is deformed or damaged, replace it together with the windshield glass.

      • If the forward recognition camera has been struck or dropped, replace it with a new one.

      • Do not apply excessive force.