STARTER INSTALLATION

PROCEDURE


  1. INSTALL STARTER ASSEMBLY


    1. Install the starter assembly with the 2 bolts.

      Torque:
      37 N*m  { 377 kgf*cm, 27 ft.*lbf }

    2. Connect the starter assembly connector.

    3. Connect terminal 30 with the nut.

      Torque:
      9.8 N*m  { 100 kgf*cm, 87 in.*lbf }

    4. Install the terminal cap.

  2. INSTALL NO. 1 TRANSMISSION CONTROL CABLE BRACKET


    1. Install the No. 1 transmission control cable bracket with the 2 bolts.

      Torque:
      12 N*m  { 122 kgf*cm, 9 ft.*lbf }

  3. CONNECT TRANSMISSION CONTROL CABLE ASSEMBLY


    1. Install a new clip to the No. 1 transmission control cable bracket.

    2. B005ODOC10
      *1 Transmission Control Cable Assembly
      *2 No. 1 Transmission Control Cable Bracket
      *a Claw (A)
      *b Claw (B)

      Connect the transmission control cable assembly to the No. 1 transmission control cable bracket.

      Note


      • Make sure that the claws (A) of the clip are securely fit into the bracket holes.

      • Make sure that the transmission control cable assembly is securely installed inside of the claws (B) of the clip.

    3. Using a screwdriver, engage the 4 claws.

  4. INSTALL AIR CLEANER CASE SUB-ASSEMBLY

    Click here

  5. INSTALL AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY

    Click here

  6. INSTALL AIR CLEANER CAP SUB-ASSEMBLY

    Click here

  7. INSTALL INLET AIR CLEANER ASSEMBLY

    Click here

  8. INSTALL COOL AIR INTAKE DUCT SEAL

    Click here

  9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here