EXHAUST MANIFOLD COMPONENTS
ILLUSTRATION
| *1 | NO. 2 ENGINE UNDER COVER | *2 | FRONT FLOOR COVER LH |
ILLUSTRATION
| *1 | FRONT EXHAUST PIPE ASSEMBLY | *2 | NO. 1 EXHAUST PIPE SUPPORT BRACKET (for Lower Side) |
| *3 | FRONT NO. 3 EXHAUST PIPE SUB-ASSEMBLY | *4 | COMPRESSION SPRING |
| *5 | EXHAUST PIPE GASKET | - | - |
 |
N*m (kgf*cm, ft.*lbf): Specified torque | ● | Non-reusable part |
ILLUSTRATION
| *1 | MANIFOLD STAY | *2 | EXHAUST MANIFOLD (TWC: Front Catalyst) |
| *3 | EXHAUST MANIFOLD TO HEAD GASKET (for Bank 1) | *4 | ENGINE OIL LEVEL DIPSTICK GUIDE |
| *5 | ENGINE OIL LEVEL DIPSTICK | *6 | O-RING |
| *7 | V-BANK COVER SUB-ASSEMBLY | *8 | NO. 2 EXHAUST MANIFOLD HEAT INSULATOR |
| *9 | AIR FUEL RATIO SENSOR (for Bank 2) | *10 | NO. 2 MANIFOLD STAY |
| *11 | NO. 2 COOLING FAN MOTOR CONNECTOR | *12 | NO. 1 RADIATOR HOSE |
| *13 | EXHAUST MANIFOLD ASSEMBLY LH (TWC: Front Catalyst) | *14 | EXHAUST MANIFOLD TO HEAD GASKET (for Bank 2) |
| *15 | AIR FUEL RATIO SENSOR (for Bank 1) | *16 | STUD BOLT |
| |
N*m (kgf*cm, ft.*lbf): Specified torque | * | For use with SST |
| ● | Non-reusable part | - | - |