CANISTER(w/o Canister Pump Module) INSTALLATION

PROCEDURE

1. INSTALL CANISTER (CHARCOAL CANISTER ASSEMBLY)

   
   

   1. Engage the clip and install the canister (charcoal canister assembly) to the vehicle body and guide with the 3 nuts.

      Torque:

      5.5 N*m  { 56 kgf*cm, 49 in.*lbf }

   2. Type A:

      
      

      1. Connect the outlet charcoal canister tube sub-assembly to the canister (charcoal canister assembly) and slide the clip to secure it.

         

         *1	Charcoal Canister Hose	*2	Outlet Charcoal Canister Tube Sub-assembly
         *a	2 to 7 mm (0.0787 to 0.276 in.)	*b	120°
         *c	Upper	-	-

         Tech Tips

         Engage the clip within the area shown in the illustration.

      2. Connect the charcoal canister hose to the fuel tube and slide the clip to secure it.

         Tech Tips

         Engage the clip within the area shown in the illustration.

   3. Type B:

      
      

      1. Engage the clamp and connect the outlet charcoal canister tube sub-assembly.

      2. Connect the outlet charcoal canister tube sub-assembly to the canister (charcoal canister assembly) and slide the clip to secure it.

         

         *1	Charcoal Canister Hose	*2	Outlet Charcoal Canister Tube Sub-assembly
         *a	2 to 7 mm (0.0787 to 0.276 in.)	*b	120°
         *c	Upper	-	-

         Tech Tips

         Engage the clip within the area shown in the illustration.

      3. Connect the charcoal canister hose to the fuel tube and slide the clip to secure it.

         Tech Tips

         Engage the clip within the area shown in the illustration.

   4. 

      *a	Retainer
      *b	Claw
      	Push
      	Push in

      Push the fuel tank vent hose sub-assembly onto the canister (charcoal canister assembly) and push in the retainer to engage the 2 claws.

      Note

      
      

      • Check that there are no scratches or foreign matter around the connecting parts of the fuel tank vent hose sub-assembly and pipe (canister (charcoal canister assembly)) before performing this work.

      • After connecting the fuel tank vent hose sub-assembly, check that the fuel tank vent hose sub-assembly is securely connected by pulling on the tube connector.

2. INSTALL CHARCOAL CANISTER PROTECTOR

   
   

   1. Install the charcoal canister protector with the 3 bolts.

      Torque:

      5.5 N*m  { 56 kgf*cm, 49 in.*lbf }

3. INSTALL TAIL EXHAUST PIPE ASSEMBLY (w/o Rear No. 2 Seat)

   
   

   1. Install 2 new exhaust pipe gaskets to the center exhaust pipe assembly (TWC: Rear Catalyst) and tail exhaust pipe assembly.

   2. Connect the tail exhaust pipe assembly to the 2 exhaust pipe supports.

   3. Install the tail exhaust pipe assembly to the center exhaust pipe assembly (TWC: Rear Catalyst) and No. 2 tail exhaust pipe assembly with the 4 bolts.

      Torque:

      55 N*m  { 561 kgf*cm, 41 ft.*lbf }

4. INSTALL TAIL EXHAUST PIPE ASSEMBLY (w/ Rear No. 2 Seat)

   Click here

5. INSPECT FOR EXHAUST GAS LEAK

   Click here