REAR CRANKSHAFT OIL SEAL INSTALLATION

PROCEDURE


  1. INSTALL REAR ENGINE OIL SEAL


    1. Using height adjustment attachments and plate lift attachments, place the engine assembly on a flat level surface.

      Note


      • Using height adjustment attachments and plate lift attachments, keep the engine assembly horizontal.

      • To prevent the oil pan sub-assembly from deforming, do not place any attachments under the oil pan sub-assembly of the engine assembly.

      • Using an engine sling device and engine lift, secure the engine assembly before service.

    2. Apply MP grease to the lip of a new rear engine oil seal.

      Note


      • Keep the lip of the rear engine oil seal free from foreign matter.

      • Do not allow MP grease to contact the dust seal.

    3. A01RD9ZC01
      *a Standard Depth

      Using SST, evenly tap in the rear engine oil seal until its surface is flush with the edge of the cylinder block sub-assembly.

      SST
      09223-15030
      09950-70010   ( 09951-07150 )
      Standard Depth
      -0.45 to 0.45 mm (-0.0177 to 0.0177 in.)

      Note


      • Keep the lip of the rear engine oil seal free from foreign matter.

      • Do not tap in the rear engine oil seal at an angle.

  2. INSTALL DRIVE PLATE AND RING GEAR SUB-ASSEMBLY


    1. A01R8YYN05

      Using SST, hold the crankshaft pulley assembly.

      SST
      09213-54015
      09330-00021

      Tech Tips

      Part number of installation bolt for SST (crankshaft pulley holding tool): 91551-80650 (quantity: 2)

    2. Clean the bolts and bolt holes.

    3. A01RAGHC02
      *a Pin Hole
      *b Pin

      Install the front drive plate spacer.

      Tech Tips

      Align the pin of the front drive plate spacer with the pin hole of the crankshaft.

    4. A01RBDBC03
      *1 Drive Plate and Ring Gear Sub-assembly
      *2 Rear Drive Plate Spacer
      B005NIZ Automatic Transaxle Side

      Install the drive plate and ring gear sub-assembly and rear drive plate spacer to the crankshaft.

      Note

      As the rear drive plate spacer and drive plate and ring gear sub-assembly are not reversible. Be sure to install them so that they are facing in the direction shown in the illustration.

    5. A01VWLIC89
      *a Adhesive

      Apply adhesive to 2 or 3 threads at the end of each of the 8 bolts.

      Adhesive
      Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent
    6. A01RDEGN02

      Install and uniformly tighten the 8 bolts in several steps in the order shown in the illustration.

      Torque:
      98 N*m  { 999 kgf*cm, 72 ft.*lbf }

      Note

      Do not start the engine for at least 1 hour after installing the drive plate and ring gear sub-assembly.

  3. INSTALL AUTOMATIC TRANSAXLE ASSEMBLY

    for 2WD: Click here

    for AWD: Click here

  4. INSPECT FOR ENGINE OIL LEAK

    Click here