HEATED OXYGEN SENSOR REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during heated oxygen sensor removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link

  • Replacement of heated oxygen sensor *1

  • Gas leak from exhaust system is repaired

 Inspection After Repair

  • Poor idle, etc.

  • Engine start function, etc.

Click here w/ Canister Pump Module

Click here w/o Canister Pump Module
*1: w/ Canister Pump Module

PROCEDURE


  1. REMOVE FRONT FLOOR COVER LH

    Click here

  2. REMOVE FRONT NO. 3 EXHAUST PIPE SUB-ASSEMBLY

    Click here

  3. REMOVE HEATED OXYGEN SENSOR (for Bank 1)


    1. B005PQ3

      Remove the wire harness clamp bracket from the heated oxygen sensor.

    2. B005OQNN01

      Using SST, remove the heated oxygen sensor from the front No. 3 exhaust pipe sub-assembly.

      SST
      09224-00011

      Note

      If the heated oxygen sensor has been struck or dropped, replace it.

  4. REMOVE NO. 1 EXHAUST PIPE SUPPORT BRACKET (for Lower Side)

    Click here

  5. REMOVE FRONT EXHAUST PIPE ASSEMBLY

    Click here

  6. REMOVE HEATED OXYGEN SENSOR (for Bank 2)


    1. B005Q74N01

      Using SST, remove the heated oxygen sensor from the front exhaust pipe assembly.

      SST
      09224-00011