THROTTLE BODY REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during throttle body with motor assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link

  • Replacement of throttle body with motor assembly

  • Cleaning the deposits from the throttle body with motor assembly

 Inspection After Repair

  • Poor idle, etc.

  • Engine start function, etc.

Click here w/ Canister Pump Module

Click here w/o Canister Pump Module

CAUTION:

Do not remove the radiator cap sub-assembly or radiator drain cock plug while the engine and radiator assembly are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.

B005QFE

PROCEDURE


  1. DRAIN ENGINE COOLANT

    Click here

  2. REMOVE AIR CLEANER CAP WITH AIR CLEANER HOSE


    1. B005L9A

      Disconnect the mass air flow meter sub-assembly connector.

    2. Disengage the wire harness clamp.

    3. B005MONC01
      *1 No. 1 Fuel Vapor Feed Hose
      *2 No. 2 Ventilation Hose

      Disengage the No. 1 fuel vapor feed hose from the air cleaner hose assembly.

    4. Slide the clip and disconnect the No. 2 ventilation hose from the air cleaner hose assembly.

    5. B005NHPC01
      *a Air Cleaner Cap Clamp
      *b Guide

      Disengage the 2 air cleaner cap clamps.

    6. Open the air cleaner cap sub-assembly and remove the air cleaner filter element sub-assembly from the air cleaner case sub-assembly.

    7. Disengage the 2 guides to separate the air cleaner cap sub-assembly from the air cleaner case sub-assembly.

    8. B005LBS

      Loosen the hose clamp and remove the air cleaner cap with air cleaner hose from the throttle body with motor assembly.

  3. REMOVE THROTTLE BODY WITH MOTOR ASSEMBLY


    1. B005NHCC01
      *1 No. 2 Water By-pass Hose
      *2 No. 3 Water By-pass Hose

      Slide the 2 clips and disconnect the No. 2 water by-pass hose and No. 3 water by-pass hose from the throttle body with motor assembly.

    2. B005OI7

      Disconnect the throttle body with motor assembly connector.

    3. Remove the 4 bolts and throttle body with motor assembly from the intake air surge tank assembly.

      Note

      If the throttle body with motor assembly has been struck or dropped, replace it.

  4. REMOVE THROTTLE BODY GASKET


    1. B005M27

      Remove the throttle body gasket from the intake air surge tank assembly.