ENGINE COOLANT TEMPERATURE SENSOR REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during engine coolant temperature sensor removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Replacement of engine coolant temperature sensor Inspection After Repair

  • Poor idle, etc.

  • Engine start function, etc.

Click here

CAUTION:

Do not remove the radiator cap sub-assembly or radiator drain cock plug while the engine and radiator assembly are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.

B005QFE

PROCEDURE


  1. DRAIN ENGINE COOLANT

    Click here

  2. PRECAUTION

    Note

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

    Click here

  3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  4. REMOVE AIR CLEANER CAP WITH AIR CLEANER HOSE

    Click here

  5. REMOVE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY

    Click here

  6. REMOVE AIR CLEANER CASE SUB-ASSEMBLY

    Click here

  7. REMOVE ENGINE COOLANT TEMPERATURE SENSOR


    1. B005M02

      Disconnect the engine coolant temperature sensor connector.

    2. B005LPHC01
      *1 Gasket

      Using SST, remove the engine coolant temperature sensor.

      SST
      09817-33191

      Note

      If the engine coolant temperature sensor has been struck or dropped, replace it.

    3. Remove the gasket from the engine coolant temperature sensor.