THROTTLE BODY INSTALLATION

PROCEDURE


  1. INSTALL NO. 2 AIR TUBE GASKET


    1. A01RFERC01
      *a Protrusion

      Install a new No. 2 air tube gasket to the intercooler assembly with the protrusion of the No. 2 air tube gasket oriented as shown in the illustration.

  2. INSTALL THROTTLE BODY GASKET


    1. A01VWIOC01
      *a Protrusion

      Install a new throttle body gasket to the No. 2 air tube with the protrusion of the throttle body gasket oriented as shown in the illustration.

    2. A01RDY0C01
      *a Protrusion

      Install a new throttle body gasket to the intake manifold with the protrusion of the throttle body gasket oriented as shown in the illustration.

  3. INSTALL THROTTLE BODY WITH MOTOR ASSEMBLY

    Tech Tips

    Perform "Inspection After Repair" after replacing the throttle body with motor assembly.

    Click here


    1. Install the throttle body with motor assembly and No. 2 air tube to the intake manifold with the 4 bolts.

      Torque:
      10 N*m  { 102 kgf*cm, 7 ft.*lbf }
    2. A01RCILN01

      Temporarily install the No. 2 air tube to the intercooler assembly with the 4 bolts.

      Tech Tips

      Tighten the bolts in the order shown in the illustration.

    3. Tighten the 4 bolts.

      Tech Tips

      Tighten the bolts in the order shown in the illustration.

      Torque:
      10 N*m  { 102 kgf*cm, 7 ft.*lbf }

    4. Connect the No. 2 water by-pass hose and No. 1 water by-pass hose to the throttle body with motor assembly and slide the 2 hose clamps to secure them.

    5. Install the wire harness clamp bracket to No. 2 air tube with the bolt.

      Torque:
      8.4 N*m  { 86 kgf*cm, 74 in.*lbf }

    6. Engage the engine wire clamp.

    7. Connect the throttle body with motor assembly connector.

  4. INSTALL NO. 2 ENGINE UNDER COVER

    Click here

  5. ADD ENGINE COOLANT

    Click here

  6. INSPECT FOR COOLANT LEAK

    Click here

  7. PERFORM INITIALIZATION

    Note


    • Be sure to perform this procedure after removing and reinstalling the throttle body with motor assembly or any throttle body with motor assembly components.

    • Perform the following procedure after replacing the throttle body with motor assembly or any throttle body with motor assembly components. The following procedure should also be performed if the throttle body with motor assembly is cleaned.


    1. Connect the GTS to the DLC3.

    2. Clear the DTCs.

      Click here

    3. Perform "Inspection After Repair".

      Click here

    4. Start the engine and check that the MIL is not illuminated. After the engine is warmed up, check that the idle speed is within the specified range with the A/C switch off.

      Standard
      750 to 850 rpm

      Note


      • Be sure to perform this step with all accessories off.

      • Make sure that the shift lever is in P or N.

    5. Enter the following menus: Powertrain / Engine / Data List / Throttle Sensor Position.


      Powertrain > Engine > Data List
      Tester Display
      Throttle Sensor Position

    6. Fully depress the accelerator pedal and check that the value of Throttle Sensor Position is 60% or higher.

    7. Perform a road test and confirm that there are no abnormalities.