INITIALIZATION
Note
Before replacing the ECM, refer to Service Bulletin (for Immobiliser System).
Before replacing the ECM, store the heavy knock history. After replacement, write the heavy knock history to the new ECM.
Initialize the heavy knock history after replacing the piston rings.
Perform Registration (VIN registration or frame number registration) when replacing the ECM.
Perform Registration (Switch Battery Type) when replacing the ECM.
Make sure to perform Reset Memory (A/T initialization), when replacing the automatic transaxle assembly, ECM or engine assembly.
for 2WD: Click here
for AWD: Click here
When the cable is disconnected from the negative (-) battery terminal, initialize the following system(s) after the cable is reconnected.
| System Name | See Procedure |
|---|---|
| LKA/LDA System | |
| Stop and Start System | |
| Intelligent Clearance Sonar System | |
| Parking Assist Monitor System (w/ Parallel Parking Assist Function) | |
| Parking Assist Monitor System (w/o Parallel Parking Assist Function) | |
| Panoramic View Monitor System | |
| Power Door Lock Control System | |
| Pre-Crash Safety System | |
| Power Back Door System | |
| Lighting System (EXT) | |
| Adaptive High Beam System |
WHEN USING GTS
CAUTION:
Observe the following items for safety reasons:
Before using the GTS, read the instruction manual.
Prevent the GTS cable from being caught on the pedals, shift lever or steering wheel when driving with the GTS connected to the vehicle.
When driving the vehicle for testing purposes using the GTS, 2 persons are required. One to drive the vehicle, and another to operate the GTS.