ABSORBER CONTROL SWITCH INSPECTION

PROCEDURE


  1. INSPECT ABSORBER CONTROL SWITCH (COMBINATION SWITCH ASSEMBLY)


    1. B005PJOC18
      *a

      Component without harness connected

      (Absorber Control Switch (Combination Switch Assembly))

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Switch Condition Specified Condition
      8 (B) - 1 (GND) Normal position ON Below 10 Ω
      Normal position OFF 10 kΩ or higher
      7 (P) - 1 (GND) SPORT position ON Below 10 Ω
      SPORT position OFF 10 kΩ or higher

      If the result is not as specified, replace the absorber control switch (combination switch assembly).