SUSPENSION CONTROL ECU INSTALLATION

PROCEDURE


  1. INSTALL ABSORBER CONTROL ECU


    1. B005PTCC02
      *a Claw

      Engage the claw of the absorber control ECU to the vehicle body.

    2. Install the absorber control ECU with the 2 bolts.

      Torque:
      6.5 N*m  { 66 kgf*cm, 58 in.*lbf }

      Note


      • Avoid any impact to the absorber control ECU.

      • Do not drop the absorber control ECU. If it is dropped, replace it with a new one.

    3. Connect the 2 connectors to the absorber control ECU.

  2. INSTALL DECK TRIM SIDE PANEL ASSEMBLY LH

    Click here

  3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  4. PERFORM TEST MODE PROCEDURE

    Note

    After replacing the absorber control ECU, it is necessary to perform registration of vehicle identification information. Vehicle identification information is automatically acquired when the system enters test mode.

    Click here