AHS ECU INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The following procedure listed below is for LH side.

PROCEDURE


  1. PRECAUTION

    Note


    • Handle components indoors as much as possible to prevent foreign matter from entering and adhering to headlight assembly components.

    • Do not reuse parts which have reduced fastening ability due to thread damage.

    • When installing components, make sure that the wire harness is not pinched or pulled.

    • Do not use solvent to clean components. Only clean them with a dry cloth.

  2. INSTALL HEADLIGHT LIGHT CONTROL ECU SUB-ASSEMBLY

    Note


    • Prevention of static electricity is required during this procedure.

    • Use static electricity countermeasures SST (desktop antistatic mat set) and observe all precautions to prevent damage to the system by electrostatic discharge (ESD).

    • Perform work using clean rubber gloves.

    • Do not touch the headlight light control ECU sub-assembly connector with bare hands.

    SST
    09890-47010   ( 09891-04010, 09891-04020, 09891-04030, 09891-04040 )

    1. Install a new headlight light control ECU sub-assembly gasket.

    2. Connect the 2 connectors.

    3. Install the cover.

    4. Install the headlight light control ECU sub-assembly with the 3 screws.

  3. INSTALL HEADLIGHT ASSEMBLY

    Click here

  4. ADJUST HEADLIGHT AIMING

    Click here