HEIGHT CONTROL SENSOR REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the rear height control sensor sub-assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedure Effect/Inoperative when not Performed Link
Disconnect cable from negative battery terminal Memorize steering angle neutral point Parking assist monitor system

Click here

LKA/LDA system

Click here

Pre-collision system
Reset power trunk lid Power trunk lid system

Click here

Removal/installation of rear height control sensor sub-assembly

  1. Synchronize the vehicle information

  2. Perform headlight control computer assembly LH initialization

 Headlight leveling function

Click here

PROCEDURE


  1. PRECAUTION

    Note

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

    Click here

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Click here

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  3. REMOVE REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY


    1. B002DMGC01
      *a Clamp
      *b Guide

      Disconnect the connector.

    2. Disengage the clamp.

    3. Remove the 2 bolts and nut.

    4. Disengage the guides to remove the rear height control sensor sub-assembly.

      Note

      Do not drop the rear height control sensor sub-assembly. If it is dropped, replace it with a new one.