REAR DOOR BELT MOULDING REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the rear door belt moulding removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure	Necessary Procedure	Effect/Inoperative when not Performed	Link
Removal/installation of rear door belt moulding	Initialize power window control system	Auto up and down function Jam protection function Catch protection function Remote control function Key-linked function Wireless transmitter-linked function Key-off operation function Window open warning function	Click here
Disconnect cable from negative battery terminal	Memorize steering angle neutral point	Parking assist monitor system	Click here
		LKA/LDA system	Click here
		Pre-crash safety system
		Adaptive high beam system
	Reset power trunk lid	Power trunk lid system	Click here

Tech Tips

Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.

PROCEDURE

PRECAUTION

Note

After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

Click here
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

Click here

Note

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click here
REMOVE REAR DOOR GLASS SUB-ASSEMBLY

Click here

REMOVE REAR DOOR BELT MOULDING

	Push
	Protective Tape
	Remove in this Direction

Apply protective tape around the rear door belt moulding as shown in the illustration.

Using a screwdriver, disengage the claws to remove the rear door belt moulding.
Remove the protective tape.