HEADLIGHT DIMMER SWITCH REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the headlight dimmer switch assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedure Effect/Inoperative when not Performed Link
Disconnect cable from negative battery terminal Memorize steering angle neutral point Parking assist monitor system

Click here

Lane departure alert system (w/ Steering Control)

Click here

Pre-crash safety system
Adaptive high beam system
Reset power trunk lid Power trunk lid system

Click here

Removal/installation of spiral cable with sensor sub-assembly

  • Steering angle neutral point (Initialize parking assist monitor system)

  • Steering angle setting

 Parking assist monitor system

Click here

Note


  • Do not replace the spiral cable with sensor sub-assembly with the battery connected and the engine switch on (IG).

  • Do not rotate the spiral cable with sensor sub-assembly without the steering wheel assembly installed, with the battery connected and the engine switch on (IG).

  • Ensure that the steering wheel assembly is installed and aligned straight when inspecting the steering sensor.

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

PROCEDURE


  1. PRECAUTION

    CAUTION:

    Be sure to read Precaution thoroughly before servicing.

    Click here

    B002C8O

    Note

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

    Click here

  2. REMOVE SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY

    Click here

  3. REMOVE TILT AND TELESCOPIC SWITCH

    Click here

  4. REMOVE WINDSHIELD WIPER SWITCH ASSEMBLY

    Click here

  5. REMOVE HEADLIGHT DIMMER SWITCH ASSEMBLY


    1. B002EOIC01
      B002C8N Remove in this Direction

      Disconnect the connector.

    2. Disengage the claws to remove the headlight dimmer switch assembly as shown in the illustration.