HAZARD WARNING SWITCH INSPECTION

PROCEDURE


  1. INSPECT HAZARD WARNING SIGNAL SWITCH (RADIO RECEIVER ASSEMBLY)


    1. Check the resistance.


      1. A01QD30C07
        *a

        Component without harness connected

        (Hazard Warning Signal Switch (Radio Receiver Assembly))

        Measure the resistance according to the value(s) in the table below.

        Standard Resistance
        Tester Connection Condition Specified Condition
        9 (HAZ) - Body ground Hazard warning signal switch off 1 MΩ or higher
        Hazard warning signal switch on Below 125 Ω

        If the result is not as specified, replace the hazard warning signal switch (radio receiver assembly).