| DTC Code | DTC Name |
|---|---|
| B242E | Open in IG Circuit |
DESCRIPTION
This DTC is stored when a malfunction occurs in the headlight control computer assembly LH IG power source circuit. The headlight control computer assembly LH stores DTC B242E.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| B242E | Open in IG Circuit | Open in the headlight control computer assembly LH IG power source circuit |
|
WIRING DIAGRAM
| *a | from LH-IG1 RLY1 Relay |
| *b | Headlight Control Computer Assembly LH |
CAUTION / NOTICE / HINT
Note
Inspect the fuses for circuits related to this system before performing the following procedure.
If the headlight control computer assembly LH has been replaced, it is necessary to synchronize the vehicle information and initialize the headlight light control ECU sub-assembly LH.
PROCEDURE
CLEAR DTC
Clear the DTCs.
| Result | ||
|---|---|---|
|
| NEXT |
|
CHECK FOR DTC
Turn the engine switch on (IG).
Check for DTCs.
| OK |
|---|
| DTC B242E is not output. |
| Result | |||
|---|---|---|---|
|
| OK |
|
USE SIMULATION METHOD TO CHECK Click here |
| NG |
|
CHECK HARNESS AND CONNECTOR (HEADLIGHT CONTROL COMPUTER ASSEMBLY RH - POWER SOURCE AND BODY GROUND)
Disconnect the A29 headlight control computer assembly LH connector.
Measure the voltage according to the value(s) in the table below.
| Standard Voltage | |||||||||
|---|---|---|---|---|---|---|---|---|---|
|
Measure the resistance according to the value(s) in the table below.
| Standard Resistance | ||||||
|---|---|---|---|---|---|---|
|
| Result | |||
|---|---|---|---|
|
| OK |
|
REPLACE HEADLIGHT CONTROL COMPUTER ASSEMBLY LH Click here |
| NG |
|
REPAIR OR REPLACE HARNESS OR CONNECTOR |