Note
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during headlight control computer assembly LH removal/installation are shown below.
| Performed Work or System Condition | Necessary Procedures | Link |
|---|---|---|
| Replacement of the headlight control computer assembly LH | Synchronize the vehicle information | |
| Perform headlight control computer assembly LH initialization | ||
| Replacement of the rear height control sensor sub-assembly, removal and reinstallation of the rear height control sensor sub-assembly, replacement of the suspension, etc. have been performed. | Perform headlight control computer assembly LH initialization | |
| Battery terminal is disconnected and connected. | Steering Sensor Zero Point Calibration |
If the steering sensor zero point calibration is not performed, the adaptive high beam system may not operate correctly.
A new headlight control computer assembly LH cannot operate until the vehicle information is registered.
After replacing the headlight control computer assembly LH, it is necessary to perform vehicle information registration and initialization.
Even if the headlight control computer assembly RH is replaced with a new one, vehicle information registration and initialization are not necessary.