AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL SYSTEM, Diagnostic DTC:B2452

DTC Code DTC Name
B2452 Height Control Sensor Data Out of Range When Initializing

DESCRIPTION

The headlight control computer assembly LH stores this DTC if the sensor value received from the rear height control sensor sub-assembly LH is out of range when performing initialization of the headlight control computer assembly LH; for example, the vehicle is not level or being jack up.

DTC No. Detection Item DTC Detection Condition Trouble Area
B2452 Height Control Sensor Data Out of Range When Initializing Rear height control sensor sub-assembly LH value is out of range when initializing

  • Vehicle condition when initializing

  • Rear height control sensor sub-assembly LH

CAUTION / NOTICE / HINT

Note

If any of the following are performed, it is necessary to initialize the headlight light control ECU sub-assembly LH.

Click here


  • Replacement of the rear height control sensor sub-assembly LH

  • Removal/installation of the rear height control sensor sub-assembly LH

  • Work that changes the vehicle height such as replacement of suspension components

PROCEDURE


  1. CLEAR DTC


    1. Clear the DTCs.

      Click here


      Body Electrical > AFS > Clear DTCs
      Result
      Proceed to
      NEXT

    NEXT

  2. CHECK FOR DTC


    1. Turn the engine switch on (IG).

    2. Check for DTCs.

      Click here


      Body Electrical > AFS > Trouble Codes
      OK
      DTC B2452 is not output.
      Result
      Proceed to
      OK
      NG

    OK

    USE SIMULATION METHOD TO CHECK Click here

    NG

  3. CHECK AND REPLACE REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH


    1. Check the installation condition of the rear height control sensor sub-assembly LH.

      OK
      Rear height control sensor sub-assembly LH is installed correctly.
      Result
      Proceed to
      OK
      NG

    OK

    REPLACE REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH Click here

    NG

    INSTALL PARTS CORRECTLY Click here